Description

Dimensions: Φ23mm×263mm 3.2

Net weight: 124 grams

Battery model: ICR18490

Nominal voltage: 3.7V

Capacity: 1400mAh

Power adapter (charger) input: ~100V-240V 50Hz/60Hz 0.4A Max

Power adapter (charger) output: DC 5V/1A

Built-in fuse: T1A250V

Wavelength: 385nm～515nm

Ambient temperature: +5℃～+40℃

Relative humidity: 30%～75%

Atmospheric pressure: 70kPa～106kPa

5 How to operate

5.1 Press the light curing machine time setting button to select 5, 10, 15, 20 seconds timing

between.

5.2 Press the light curing machine mode setting button to select one of the following three modes.

5.2.1 Full power mode: The blue light is irradiated at full power. (Clinical recommended mode)

5.2.2 Progressive mode: The blue light power is gradually increased from weak to the maximum power in 5 seconds.

5.2.3 Pulse mode: Blue light works in pulse mode.

5.3 When in use, aim the light source at the position to be cured, press the on/off key, the machine will press

The selected mode works, and the work ends when the timer is 0; during the irradiation process, you can press the button at any time.

ON/OFF key to stop irradiation.

5.4 After one irradiation cycle is over, the next irradiation cycle can be started immediately by pressing the on/off key

If it is obvious that the handle starts to become hot, stop working until the handle is completely cooled down.

4

To start work, it is recommended that the number of consecutive exposures should not exceed 10 times.

5.5 If the light guide rod is stained with resin after use, please wipe it with a cotton cloth to avoid affecting the

brightness.

5.6 The curing depth of the light-cured composite resin for 10 seconds shall not be less than 4mm.

5.7 The light guide rod must be removed before each use, and the temperature is 134°C and the pressure is

Sterilization and disinfection at 2.0bar～2.3bar (0.20MPa～0.23MPa) for 4 minutes.

5.8 Low voltage indication: If the mode indicator flashes during use, it means the battery is low and needs to be replaced.

Change or charge the battery.

5.9 If the machine is not used for a long time, please remove the battery and save it.

5.10 The machine has overheat protection function and can work continuously for 200 seconds, for example: 20 seconds

It can be operated continuously for 10 times, each time the button is pressed, it is counted as one time, regardless of whether the time has elapsed, even

After 10 consecutive times, it will enter the overheat protection state. After 2 minutes of sleep, the machine can be woken up and returned to normal.

Often work for 200 seconds.

6 Charging Instructions

6.1 Please charge the machine for at least 4 hours before using it for the first time.

6.2 Put the battery to be charged into the battery compartment of the charging base. The polarity of the battery should be the same as that of the battery.

The polarities marked in the cabin are the same.

6.3 Connect the power adapter to the ~100V-240V power supply, and then connect the power adapter

Insert the plug into the DC5.0V input interface of the charging base, and the charging indicator turns from green to yellow

color, indicating that charging is in progress, and the indicator turns green when charging is complete.

6.4 The battery used in this product has no memory and can be charged at any time.

6.5 After charging, please disconnect the charging power and take the battery out of the battery compartment.