1000W 20A ZVS high frequency Induction Heating Board Module Heater DC12-40V with coil
Description:
1.Whenever possible, use a protected power supply. Switching power supplies with small current and no protection should not be used.
Do not use battery or battery power!
Working voltage is guaranteed11VAbove, note: it is the voltage at work, that is, the input voltage when the coil is connected or the object is heated; it is not the voltage when the power supply is unloaded.
2.Long-term use must be done with copper tubing and water cooling!
The copper tube with a diameter of 10mm can be installed on the copper column at the output end. The diameter of the copper tube is ≤4mm. The copper tube can be welded on the copper clip and then fixed on the copper column. The diameter ≤2mm can be connected to the output terminal.
3.The use of this board requires a certain amount of hands-on ability and related knowledge, if the soldering iron will not be used, the power supply will not be divided, it is recommended not to shoot!
Specification:
1.Input Voltage:DC 12-40V
2.Max Input Current:50A (short time)
3.When 12V for power supply,the current should be no less than 20A;when 24V for power supply,the current should be no less than 30A;when 36V for power supply,the current should be no less than 50A
4.Operating Voltage:>=11V
5.Output port copper cylinder can most install copper tube of 10mm diameter;when the copper diameter is no more than 4mm,you can solder the copper tube on the clip then fix the copper cylinder;when the diameter is no more than 2mm,it can be connected with output terminal
6.PCB Size:165.1*112.41*1.6mm
