DC 5V 6V 9V 12V 15V 24V Step Up Boost Converter Power Supply Module DD1718PA with pins 3-18V to Positive and Negative Boost Module

Description:

Input voltage DC 3 ~ 4.5V,output DC ±5V(Deviation is ±5%)

Maximum input current 2A

Maximum output current : +Vo is 1A,-Vo is 200mA

Input voltage DC 3 ~ 5V,output DC ±6V(Deviation is ±5%)

Maximum input current 2A

Maximum output current : +Vo is 1A,-Vo is 200mA

Input voltage DC 3.3~ 8V,output DC ±9(Deviation is ±4%)

Maximum input current 1.8A

Maximum output current : +Vo is 800mA,-Vo is 180mA

Input voltage DC 3.3~ 11V,output DC ±12(Deviation is ±4%)

Maximum input current 1.8A

Maximum output current : +Vo is 700mA,-Vo is 150mA

Input voltage DC 3.3~ 13V,output DC ±15(Deviation is ±4%)

Maximum input current 1.8A

Maximum output current : +Vo is 600mA,-Vo is 120mA

Input voltage DC 3.6~ 18V,output DC ±24(Deviation is ±4%)

Maximum input current 1.8A

Maximum output current : +Vo is 400mA,-Vo is 100mA

DC DC Boost Converter Module working frequency 400kHz.

Operating temperature range : -40~+125 Degrees Celsius

Storage temperature range : -65~+150 Degrees Celsius

2.54mm pin pitch,for MCU Development Board Breadboard friendly.

Size : 25 x 16.3 x 6.6mm

Weight :with Pin 3.4g,no Pin 3g

High efficiency up to 90%

Built in Frequency Compensation

Built in Soft-Start Function

Built in Thermal Shutdown Function

Built in Current Limit Function

1 Due to the diode partial pressure, the voltage of -Vo is lower than +Vo

2 In order to obtain a more stable voltage, it is recommended that the output is greater than 15MA

3 -Vo cannot be used alone, or no voltage output.But you can just use +Vo

ADC/DAC/Operational Amplifier

RS232 RS485 RS422 Bus

Audio equipment

LCD power supply

Instrumentation equipment

MCU Board

Motor Power

Instrumentation multimeter

Wifi/Router/Ethernet devices

This is a DC-DC voltage converter module,Must be noted when using:

1 Input voltage can not be greater than the maximum input range

2 Output power can not be greater than the maximum load for a long time

3 Input power must be greater than the output power, because the power consumption of the module itself