Description

Product Parameters Module name: 600W boost constant current module

Module nature: non isolated boost module (boost)

Input voltage: two input voltage ranges are optional (selected by jumpers on the board)

① 8-16V input (for the application of three series lithium batteries and 12V batteries) in this input state, do not over pressure input Otherwise, the module will be burned!!!

② 12-60V input factory default range (for wide input voltage range applications)

Input current: 16A (MAX). If it exceeds 10a, please strengthen heat dissipation

Static working current: 15mA (when 12V rises to 20V, the higher the output voltage, the higher the static current will increase)

Output voltage: 12-80V continuously adjustable (the default output is 19v. If you need other voltages, please explain to the shopkeeper.)

12-80V fixed output (for batch customers)

Output current: 12A MAX more than 10A, please strengthen heat dissipation (related to the input and output differential pressure. The larger the differential pressure is, the smaller the output current is)

Constant current range: 0.1-12A

Output power: = input voltage*10A,

for example: input 12V*10A = 120W, input 24V*10A = 240W,

Input 36V*10A = 360W, input 48V*10A = 480W, input 60V*10A = 600W

For higher power, two modules can be used in parallel. For example, the output should be 15A. Two modules can be used in parallel, and the current of each module can be adjusted to 8A.

Working temperature: - 40 ~ + 85 ℃ (please strengthen heat dissipation when the ambient temperature is too high)

Working frequency: 150KHz

Conversion efficiency: up to 95% (efficiency is related to input and output voltage, current and voltage difference)

Over current protection: Yes (if the input exceeds 17a, the output voltage will be automatically reduced with a certain range of error.)

Short circuit protection: with (input 20A fuse) double short circuit protection, it is safer to use.

Input reverse connection protection: none, (please connect diodes in series at the input if necessary)

Output anti backflow: Yes, no anti backflow diode is required for charging.

Installation method: two 3mm screws

Wiring mode: welding free output of wiring terminal

Module size: 75mm long, 60mm wide and 56mm high

Module unit weight: 205g

Applied Range

1. DIY is a regulated power supply, input 12V, output 12-80V adjustable.

2. Supply power to your electronic equipment. You can set the output value according to your system voltage.

3. As an on-board power supply for your laptop, PDA or various digital products.

4. DIY, a high-power mobile power supply for notebooks: with a large capacity of 12V lithium battery pack, your notebook can be lit wherever it goes.

5. Voltage stabilization of solar panels.

6. Charge batteries, lithium batteries, etc.

7. Drive high-power LED lamp.

Operating Instructions

1. Selection of input voltage range: the factory default is 12-60V input. When you use 12V battery or three or four string lithium batteries, you can short-circuit the jumper above with jumper cap and select 9-16V input.

2. Output current regulation method:

① Adjust the CV potentiometer and set the output voltage to the voltage value you need according to your battery or LED. For example, the voltage of 10 strings of LEDs is adjusted to 37V, and the voltage of four strings of batteries is adjusted to 55V.

② Set the CC potentiometer counterclockwise for about 30 turns, set the output current to the minimum, connect the LED, and adjust the CC potentiometer to the current you need. For battery charging, after discharging the battery, connect it to the output and adjust the CC to the current you need. (when charging, be sure to adjust it with the discharged battery, because the more the battery remains, the smaller the charging current.) Please do not adjust the current by short circuit. The circuit structure of the boost module cannot be adjusted by short circuit.