Brand name: ADT-LINK

Product name: USB 3.1 Type-C male to Type-C male flat cable

Product model: UTT3-MM-13P series

Transfer speed: USB 3.1 standard 10G/bps ( gen2x1 10Gbps within 50cm ; gen1x1 5Gbps within 1 meter )

Wire length: 3~300 cm, the length can be customized,

Current capacity: 3A within 50cm ; 1.5A within 1 meter

Product application: GPS navigator, storage device, imaging device, ROCK Pi 4 Raspberry Pi MCU development board, built-in USB device extension, convenient for USB power supply and USB signal transmission of SLR handheld gimbal, etc.

Procurement Tips: Be sure to buy 1~2 samples first and then purchase in bulk after testing and verifying that they are correct.

Purchase restriction: This product is designed to connect to built-in USB devices. It is not suitable for general external use. It is limited to the product engineer to specify the purchase. Individual buyers should not place an order for purchase. This product has a fragile structure and is not suitable for civilian use. It is not easy to use for general purposes.

ADT USB series Part-Number Description:

S=USB-A ; C=USB-C ; W=USB-B ; F=USB-E

Cable length Description:

The length of the wire refers to the part of the visible wire. It does not include the PCB and the connector. For the wire length, please refer to the 5cm blue arrow in the figure below.

  Product Model description:

Note 1: Speed bandwidth: The cable length supports gen2 speed 10Gbps within 50cm, and supports gen1 speed 5Gbps within 1 meter. Note 2: The male-to-male TX-RX signals are directly exchanged, and there is no need to distinguish the master and slave terminals when using them directly.. Note 3: It is forbidden to use two USB cables in series in reverse, otherwise the USB function will fail. This is a limitation of USB definition, not a design problem. Product Image:

Product real shot:  

Summary of technical issues:

Can wires and PCB connectors be split?

No, in order to purify the signal transmission and avoid the accident of wire falling off, our wire and PCB connectors is soldering and protected by the heat shrinkable tube sleeve, so the product can not be separated.

Cable thickness? Can it be bent?

The thickness of the wire is 1.4mm,and it can be bent and folded without affecting the use.

Is there any EMI shielding for Cable?

No metal shield. The extender utilizes the latest materials for EMI shielding with five sole flat cables design. This technique allows each cable to be fully covered by electromagnetic interference shielding with conducting polymer to guard against incoming or outgoing emissions of electromagnetic frequencies, minimize disturbance and degradation on performance, and reduce the weight of the extender.