Description

Touch Switch Capacitive Module 5V-24V 3A LED Dimming Control Lamps Active Components Spring Touch Switch Sensor

Parameter:

Input voltage: 9v-24v

2. Output voltage: 9v-24v

Load power: 30W

4. Load current: 3A

Standby current: 10mA

Standby power consumption: 0.1w

7. Working temperature: -20°C~65°C

8. Type: Touch_S (L40W10)

9. Size: 40mm*10mm*1.2mm

(Note: Test condition Vin = 12V)

Instructions for use:

Module size 40mm*10*1.2(mm), hard light or other light fixtures with width >= 10mm;

Using a wide voltage working program, the input voltage is 9V to 24V,

Note that the output load voltage is approximately equal to the input voltage;

The module has better anti-interference and adaptability, and is widely used in civil hard light control

The status of this version LED is always on.

This series is a 4-in-1 version of the model,

The default factory setting is unidirectional dimming

Mode description:

Touch_Sensor_S00 (general switch):

S00 mode, quick switch light on/off state, no dimming function. Effect gradient.

Touch_Sensor_S01 (one-way dimming):

S01 mode, quick switch light on/off state;

In the open case, long touch enters one-way dimming

(keep in touch, dim to max or min brightness, automatically stop dimming),

Release Lock Brightness,

Toggle brightness is the final locked brightness.

In the off state, long touches will dim

From previous brightness to brighter direction.

Effect gradient.

Touch_Sensor_S02 (cycle dimming)

S02 mode, quick switch lighting on/off state;

When on, long touch enters periodic dimming (keep the touch, dim to max or min brightness)

automatically light in the opposite direction, so loop), let go of locked brightness,

Toggle brightness is the final locked brightness.

In the off case, long touches will dim

previous brightness to brighter direction. Effect gradient.

Touch_Sensor_S03 (three-stage dimming)

S03 mode, quickly switch the lighting state. Brightness three,

30%, 60%, 100%, respectively, switching effect gradients.

Notice:

It needs to be installed and then powered on. If a power supply is installed,

Environmental parameters may be altered that may affect sensitivity.

Touch spring installation please avoid touching

As the electromagnetic signal in the compound contact changes,

Try to avoid using heavy water as a steam environment,

to prevent possible malfunctions.

Please understand the use parameters of the product before use

Bag

1 PCS* touch sensor switch